Toyota Camry Strut Mount Noise: Common Fixes for 6th and 7th Gen
Symptoms
- Clunk or pop when turning at standstill or low speed
- Front creak over bumps
- Notchy steering return
- Binding steering when severe
Causes
Camry uses a MacPherson front end; the mount assembly holds a thrust bearing. Long mileage and rough roads dry the grease, wear the raceway or age the rubber.
- Bearing wear: main noise source
- Rubber aging: bump noise and alignment shift
- Seal failure: faster damage
Inspection
- Lift and check rubber for cracks
- Rotate the bearing for catch and play
- Remove the cap to view balls and grease
Replacement
- Replace in pairs
- Use a spring compressor, mind orientation
- Torque the top nut to spec
- Align afterwards
Parts Choice
Camry volumes are large and aftermarket quality varies. Huami builds OE-spec Camry mount bearings.